JVC KD-HDR20 User Manual

5 Use the Sluetooth device to search and
connect.
On the device to be connected, enter the same
PIN code you have just entered for this unit.
"CONNECTED" appears on the display.
Now connection is established and you can use the
device through the unit.
The device remains registered even after you
disconnect the device. Use "CONNECT" (or activate
"AUTO CNNCT") to connect the same device from
next time on. (See the following and page 22.)
Connecting a device
1 Select liST PHONE
II
or liST AUDIO."
SRC'"
2 Select IINEW DEVICE."
5 For available devices •••
0] Enter the specific PIN code of the device to the
unit.
Refer to the instructions supplied with the
device to check the PIN code.
m Use the Bluetooth device to connect.
Now connection is established and you can use
the device through the unit.
For special device ...
Use 1I0PEN" or IISEARCH" to connect.
Connecting/disconnecting/deleting a
registered device
1 Select liST PHONE" or liST AUDIO."
SRC'"
2 Select a registered device you want to
connect/disconnect/delete.
3 To search for available devices:
Select IISEARCH."
The unit searches and displays the list ofthe
available devices. If no available device is detected,
"UNFOUND" appears.
To connect a special device:
Select IISPECIAL."
The unit displays the list of the preset devices.
4 Select a device you want to connect.
3 To connect/disconnect the selected device:
Select IICONNECT" or IIDISCONNECT."
To delete the selected device:
Select IIDELETE/' then liVES."
You can set the unit to connect the Bluetooth
device automatically when the unit is turned on.
(See "AUTO CNNCT" on page 22.)
EXTERNAL DEVICES
13

JVC KD-HDR20 Specifications

General

Brand	JVC
Model	KD-HDR20
Category	Car Receiver
Language	English