JVC LT-32DH8ZG - Connecting Your TV; Connecting to Aerial or Cable TV

English
or
Cable TV
English-13
To view the television channels correctly, a signal must be received by the
broadcasting provider.
1 Connect the RF coaxial cable from an aerial or a cable TV to the RF jack on
the rear of the TV.
2 Turn on the TV, and then press the AV button to select Digital TV or Analog
TV.
Notes:
1.
To receive an optimal signal, it is recommended that you use a 75 ohm IEC-
type coaxial cable.
2. For proper reception of signals, an external antenna is required. For best
reception, an outdoor antenna is recommended.
3.
To improve the picture quality in a poor signal area, please purchase a signal
amplier and install properly.
When attaching the TV to the wall, use the
optional JVC wall mounting unit
- Consult a qualied technician.
- See the included manual on mounting procedures.
- JVC assumes no responsibility for damage due to improper mounting.
- 200 mm x 200 mm mount which conforms to VESA standards.
Connecting to an Aerial or a Cable TV
Chapter 2 >> Connecting Your TV