Basic Settings
Some of the following settings are required a1_er connecting and positioning your speakers while others will make
operations easier. You can use QUICK SPEAKER SETUP to easily set up your speaker configuration.
Quick Speaker Setup helps you to easily and quickly register the
speaker size and speaker distance according to your listening room
to create the best possible surround effect.
• You can also register each speaker's information manually.
For details, see page 18.
5 Press in MULTI JOG (PUSH SET).
"COMPLETE" appears on the display, then goes back to the
source indication.
Note:
This procedure will not be completed if you stop in the middle of the
setting process.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start fl'om step 1 again.
1 Press QUICK SPEAKER SETUP.
"SPK"*" and the initial speaker channel number appear.
Turn MULTI JOG to select an appropriate
number of the connected speakers (speaker
channel number).
As you turn the jog, the speaker channel number changes as
follows.
* For the details of speaker channel number, see "Speaker
channel number and speaker size."
ANALOG
[] []
C::}7:JI ' , r- r-i r-t.i
....i. "_ .... 7 ,--Li,--i i,_ i i
Press in MULTI JOG (PUSH SET).
"ROOM SIZE-'*" and the initial room size setting appear.
Turn MULTI JOG to select an appropriate room
size to match to your listening room.
As you turn the ,log, the room size changes as follows.
• To select your appropriate room size, see "Room size and
speaker distance/output level."
ANALOG
[] []
i-"i i-"i i--'i !'*4 
To Next Page
Loading...
Need help?
General
