Operating Other Manufacturers' Video Equipment
1
To change the transmittable signMs for
operating another manufacturer's VCR
Press and hold STANDBY/ON Oa VCR.
To change the transmittable signals for
operating another manufacturer's DVD player
1 Press and hold STANDBY/ON V/I DVD.
2 Press VCR. 2 Press DVD.
3 Enter a manufacturer's code using buttons 1 - 9,
and O.
3 Enter a manufacturer's code using buttons 1 - 9,
and O.
Manufacturer Codes
JVC 01*, 02, 03
Emerson 10, 22
Gold Star I l
Hitachi 04
Mitsubishi 12
NEC 21
Panasonic 07, 13
Philips 09
RCA 05_06
Samsung 20
Sanyo 17, 18, 19
Sony 14, 15, 16
Zenith 08
* "01" is the initial setting.
Release STANDBY/ON V/I VCR.
Now you can perform the following operations on the VCR:
STANDBY/ON VII VCR: Turn on and off the VCR.
VCR CH +/-: Change the TV channels on the
VCR.
After pressing VCR, you can perform the following operations
on the VCR:
REW:
FF:
II:
||:
REC PAUSE:
Start playing.
Rewind the tape.
Fast-forward the tape.
Stop playing or recording.
Pause playing. To resume, press I_.
Enter recording pause.
To start recording, press this button then _.
Try to operate your VCR by pressing
STANDBY/ON V/t VCR.
When your VCR turns on or off_ you have entered the correct
code.
If there are more than one code listed for your brand of
VCR, try each one until the correct one is entered.
Manufacturer Codes
JVC 01 *
Panasonic 02
Philips (04
Pioneer 03
Sony 05
Toshiba 06
Yamaha 07
* "01" is the initial setting.
Release STANDBY/ON V/I DVD.
Now you can perform the fffllowing operations on the DVD
player:
STANDBY/ON VII DVD: Turn on and off the DVD player.
After pressing DVD, you can perform the following operations
on the DVD player:
Nt_I:
I_-I_l:
II1:
II:
Start playing.
Return to the beginning of the current (or previous)
chapter (or fast reverse for some models).
Skip to the beginning of the next chapter (or fast
forward ff)r some models).
Stop playing.
Pause playing. To resume, press I_.
After pressing DVD, these buttons
can be used fin" the DVD menu
operations.
Note:
For detailed menu operations, refer to
the instructions supplied with the discs
or the DVD player.
ENTER
@T
Try to operate your DVD player by pressing
STANDBY/ON V/I DVD.
When your DVD player turns on or off_ you have entered the
correct code.
Manufacturers' codes are subject to change without notice.
If they are changed, this remote control cannot operate the
equipment.
32
To Next Page
Loading...
Need help?
General
