JVC RX-509VTN - Speaker Setup and Connection

Before Starting
Connecting Speakers
Connecting the Front
Speakers
Connecting Speakers
You can connect the following combinations of speakers:
*
two
pairs
of
front
speakers
to
produce
normal
stereo
sound
*
one
pair
of
rear
speakers
to
produce
the
surround
sound
effect
*
one
center
speaker
for
more
effective
surround
sound
A\
CAUTION!
Use
speakers
with
the
impedance
marked
near
the
terminals.
To
connect
each
speaker,
follow
these
steps:
Step
1
Open
each
terminal
on
the
back
of
the
receiver
and
insert
the
end
of
the
speaker
wire,
as
shown.
Step
2
Close
the
terminals
to
clamp
the
speaker
wires
in
place,
as
shown.
NOTE: Use the wire supplied with the speakers.
Connect
the
front
speakers
to
the
FRONT
SPEAKERS
terminals.
Up
to
two
sets
of
front
speakers
can
be
connected.
SPEAKERS 1
Paral
Ey
®
SPEAKERS
IMPORTANT!
Be
sure
to
match
the
polarity
of
the
speaker
terminals
with
the
polarity
of
the
terminals
on
the
receiver,
(+)
to
(+)
and
{-)
to
(-).
Page 7