JVC RX-509VTN - Tone and Loudness Control; Sleep Timer Function

Adjusting Bass and Treble
Listening at Low Volume
LOUDNESS
Page 20
Adjusting the Tone
Use the BASS control to adjust low pitches and the TREBLE control to adjust high pitches.
Turn either control to the right for intensified pitch. Set both controls at the FLAT position for
normal listening.
Human ears are not sensitive to low-frequency sounds at low volume. To compensate for this,
the loudness function automatically boosts the bass level as you lower the volume.
To use the loudness function, press the LOUDNESS switch. The “LOUDNESS” indicator
lights in the display window. Press the switch again to turn the feature off.
Using the Sleep Timer
The sleep timer lets you listen to any program for up to 80 minutes before it automatically shuts
off. The receiver goes back to standby mode (off) after the time period that you specify. To
use the sleep timer:
Step 1 Press the SLEEP button on the remote control.
“SLEEP” appears in the display window.
IMPORTANT! You have 5 seconds to proceed to the next step. If you wait more
than 5 seconds, return fo step 1.
Step 2 Press the SLEEP button again to set the timer.
Each time you press the SLEEP button, the time limit is extended 10 more minutes.
You can set up to 80 minutes.
Step 3 Stop when you reach the desired time period.
The set time indicator disappears after afew seconds. The receiver will automatically
return to standby mode (off) after the time period you specified.
NOTES:
e After setting the sleep timer, you can change sources as often as you wish within the.
specified time period.
° After setting the sleep timer, you can check the remaining time in minutes by
pressing the SLEEP button. You can extend the time period further, in 10-minute
increments, by pressing the SLEEP button again.