JVC RX-509VTN - Connecting an FM Antenna

Before Starting
For Germany
For Other European
Countries
Page 10
Connecting an FM Antenna
The type of terminal provided for connecting an FM antenna depends on pone geographic area.
Read the section below which corresponds to your area.
IMPORTANT! Make sure the antenna conductors do not touch any other terminals
on the receiver. This could cause poor reception.
You have two options for connecting an FM antenna. Connect the included wire antenna as
shown in option @, or purchase antenna and cable with connector DIN 45332 and attach as
shown in option ©.
Bee oe
2 ORS
aren
®@ ®
Connect the antenna cable to the FM 75Q COAXIAL terminal using the matching transformer.
You have two options —- a 300-ohm feeder cable, or a 75-ohm coaxial cable.
To attach the matching transformer to the 300-ohm feeder cable, secure the two conductors to
the screws of the matching transformer, as shown at the left.
wren”
To attach the matching transformer to the 75-ohm coaxial cable, follow these steps:
Step 1. Remove the cover of the matching transformer by lifting the tabs on both sides.
Step 2 Remove the jumper wire from the notch in the center of the fitting.
Step 3 Wind the wire securely around the plastic pole next to the fitting.
Step 4 Insert the center conductor of the coaxial cable into the notch.
Step 5 Using a pair of pliers, secure the fitting in the center of the matching transformer so
that the shield braid of the coaxial cable is held tightly in the fitting.
Step 6 Snap the cover back onto the matching transformer.
A Ee abten &
a [2] [3] [4] G) [6]