JVC RX-509VTN - Preset Station Tuning; Manual Station Presetting

Assigning Channel
Numbe
rs
bd 2 3 4 7 @ 7 L iJ 30
| re es
= PRESET ay |
CENTER LEVEL
Manual Presetting
Page 16
MEMORY
ES)
+10
al
Presetting Tuned Frequencies
You can preset up to 40 radio stations by assigning channel numbers (1 through 40) to them.
Once a station is preset, you can listen to it by entering the preset number using the TUNER
buttons on the receiver, or the PRESET buttons of the remote. There are two ways to preset:
manual or automatic.
To choose numbers from 1 through 10, press the appropriate TUNER buttons. To choose
numbers from 11 through 40, press the +10 key and one other button. For example:
To choose 17 Press +10, then 7.
To choose 20 _— Press +10, then 10.
To choose 25 Press +10 twice, then 5.
To choose 40 _—_ Press +10 three times, then 10.
Your channel number will appear.
NOTE: You can also tune using the remote control. First press the AM or FM button
on the remote, then enter the channel number using the PRESET buttons (+ and —)
on the remote. Press + to increase the selected number, and press — to lower the
selected number.
To use manual presetting to assign channel numbers to your favorite stations, follow these
steps:
Step1 Tune toa station. If necessary, follow the procedure on page 15.
Step 2 Press the MEMORY button.
The “MEMORY” light appears in the display window.
Step 3 Using the TUNER buttons, enter anumber (1 through 40). This number is the channel
number you are assigning to the station.
IMPORTANT! You must enter the channel number while the “MEMORY” light is on.
You have about 5 seconds to do this. If the light disappears before you enter the
channel number, press the MEMORY button again.
Step 4 Whenthe MEMORY light disappears and the channel number is displayed, presetting
is completed. :