JVC RX-509VTN - Naming Preset Stations

Assigning Names to Preset Stations
Entering
Title
Characters
You
can
assign
atitle
of
up
to
four
characters
(for
example,
a
station
name)
to
each
preset
station
(1-20).
When
a
preset
station is called, its
title
is displayed in
the
display window
along
with
its
channel number.
After selecting the preset channel (1-20), enter title characters as follows:
CHARACTER Step 1 Press the CHARACTER button.
Cc) ; The cursor appears at the first character position.
IMPORTANT! You must press the CHARACTER button while a preseet number
appears. You have about 2 seconds fo do this. If the display returns to tuning
frequencies before you press the CHARACTER button, select the preset channel
again.
If a title has already been assigned, the first character blinks. If you are not changing
this character, press the CHARACTER button.
CHARACTOR INPUT Step 2 Using the DOWN and UP buttons, select the character to be entered.
DOWN uP
You can choose from the characters shown below. Pressing the DOWN or UP button
a ia selects the next character in the sequence.
BLANK ~<— DOWN * UP —>
| faletefolelFialy] tfulkieiminjo|
b(Telalsttlolviwix] vizlol [2 [214]
LTellelel Tl l-1<>
Step 3 When the desired character appears, press the CHARACTER button.
The cursor moves to the next character position. You can enter up to four characters
by repeating Steps 2 and 3.
ENTER Step 4 Press the ENTER button to save the selected characters.
Page 18