JVC RX-509VTN - Component Operation (Selected Source)

Operating the Component
Already Selected
Turntable
CD Player
Cassette Deck
Using the Remote Control
By
connecting
the
COMPU
LINK
jack
to
this
receiver,
you
can
operate
the
audio
stereo
component
with
this
receiver’s
remote
control.
In
addition,
if
your
VCR
is
aJ
VC
product,
you
can
operate
it
with
this
receiver’s
remote
control.
NOTE: The VCR does not work with the COMPU LINK remote control system. When
you operate the VCR, you must aim the remote control at the VCR instead of the
receiver.
Selecta
source
with
the
SOURCE
SELECT
buttons
on
the
remote
control.
Operate
that
source
using
the
buttons
just
below
the
SOURCE
SELECT
buttons.
IMPORTANT!
If
you
choose
a
source
on
the
receiver
directly,
the
remote
conirol
will
not
operate
that
source.
To
operate
a
source
with
the
remote
control,
the
source
must
be
selected
using
the
remote
control.
IMPORTANT!
When
you
select
CD
or
TAPE
1
on
the
remote
control,
the
component
will
turn
on
and
start
playing
automatically.
After
pressing
the
PHONO
button,
you
can
perform
the
following
operations
on
the
remote:
Starts playing
Stops playing
av
After pressing the CD button, you can perform the following operations on the remote:
Starts playing
Skips to the beginning of the previous track
Skips to the beginning of the next track
Stops playing
1 Stops playing temporarily. To release it, press
Moves backward quickly during play
Moves forward quickly during play
wmyir
vi
After
pressing
the
TAPE
1
button,
you
can
perform
the
following
operations
on
the
remote:
Starts playback
Skips to the beginning of the previous tune
Skips to the beginning of the next tune
Stops operation
Stops playback or recording temporarily. To release it, press >
Fast wind the tape from right to left
Fast wind the tape from left to right
Press together with to start recording
Press together with Il to enter record-standby mode
2 wan 2
Page 25