JVC RX-509VTN - Component Operation (Unselected Source)

Operating the Component
Not Currently Selected
CONTROL <D_ SURROUND
Ca) Ge) Gs) CO
VCR
eee
POWER
Cassette Deck
CD Player-Changer
Page 26
When you wantto operate one component while listening to another component (e.g., recording
from a CD), use the buttons in the CONTROL section of the remote control. The CONTROL
buttons allow you to use the operation buttons for the new component without affecting the
_ component already playing.
After pressing VCR (in the CONTROL section of the remote control), you can perform the
following operations on the remote:
> Starts playback
a Stops operation
il Stops playback temporarily or freezes the picture. To release it, press >
<< Rewinds video tape
Pp Fast winds video tape
° Press together with > to start recording
Press together with Il to enter record-standby mode
—* Scans to higher or lower TV channels
NOTE: You can also turn the VCR and TV on and off by pressing the VCR or TV
button in the POWER section of the remote control.
IMPORTANT! Aim the remote control at the VCR or TV, not at the receiver.
Pressing TAPE 1 in the CONTROL section of the remote allows you to perform the same
functions as pressing TAPE 1 in the SOURCE SELECT section of the remote.
After pressing the CD DISC button in the CONTROL section of the remote, you can perform
the following operations on the remote:
1-6, P Select the number of the disk installed in the CD player-changer. Then continue to
operate the CD player as shown on Page 25.