JVC RX-509VTN - Main Power Supply Connection; Remote Control Battery Installation

Before Starting
LINE VOLTS “U
AM CH. SPACING
set ue}
Connecting the Power
Supply
Inserting Batteries into the
Remote Control
Page 12
Connecting the Power
In some areas, you will find voltage selector and AM channel spacing selector switches on the
back of the receiver. If your receiver has these switches, follow the instructions below to set
them before connecting the power.
Voltage Selector: Using a Philips screwdriver, adjust the voltage selector to the correct
supply voltage for your area.
AM Channel Spacing Selector: Using the tip of a ballpoint pen, adjust the AM channel
spacing for your area.
After checking all connections, insert the power cord plug into an outlet.
When the power supply is connected correctly, the POWER STANDBY indicator lights on the
front of the receiver. A small amount of power (5 watts) is consumed under these conditions,
even if the receiver is turned off. To shut off the power completely, unplug the power cord from
the outlet.
Z\ CAUTION!
* Do not handle the power cord with wet hands.
* Do not pull on the power cord to unplug the receiver. Always grasp the plug
directly so as not to damage the cord.
¢ Do not plug the power cord into a socket until all components are connected
correctly.
IMPORTANT! If the power cord is disconnected or a power failure occurs, the
receiver settings in memory are retained for 2 or 3 days.
The remote control requires two batteries (supplied). To insert batteries, follow these steps:
Step 1 On the back side of the remote control, press down on the battery cover and slide it
out.
Step 2 Insert batteries. Make sure to observe the proper polarity: (+) to (+) and (—) to (-).
Step 3 Slide the cover in.
If the range or effectiveness of the remote control decreases, replace the batteries. Use two (2)
AAA (24F) dry-cell batteries of the RO3/UM-4 type.
A\ CAUTION! Follow these precautions to avoid leaking or cracking cells:
¢ Place batteries in the remote control so they match the polarity indicated:
(+) to (+) and (-) to (-).
¢ Use the correct type of batteries. Batteries that look similar may differ in
voltage.
¢ Always replace both batteries at the same time.
© Do not expose batteries to heat or flame.