JVC RX-509VTN - COMPU LINK-3 System Setup; Receiver AC Outlet Usage

COMPU LINK-3
Connections
Other Audio Connections
COMPU
LINK-3
SYNCHRO
jacks
on
the
back
of
the
receiver
connect
the
COMPU
LINK
remote
control
system.
This
system
connects
other
JVC
audio
components
with
the
receiver
to
make
listening
and
recording
more
convenient.
Touse
this
system,
attach
the
cables
provided
with
your
JVC
components
to
the
COMPU
LINK-3
SYNCHRO
jacks
on
the
rear
panel
of
each
component.
Then
connect
the
cables
to
the
receiver.
,
NOTES:
*
COMPU
LINK-3
is
an
upgraded
version
of
COMPU
LINK-1.
If
your
equipment
provides
COMPU
LINK-1
jacks,
you
can
still
connect
your
equipment,
but
slight
imperfections
may
result.
Automatic
Power
ON/OFF,
for
example,
may
not
always
function
properly.
¢ Refer to page 24 for details about the COMPU LINK remote control system.
A\ CAUTION! Do not connect Tape Deck 2 to the COMPU LINK jacks. It may
cause the COMPU LINK system to malfunction.
CD PLAYER
TURNTABLE
Use
the
socket
on
the
back
of
the
receiver
to
connect
the
power
supply
of
any
audio
components.
By
pressing
the
POWER
switch
on
the
remote
control,
you
can
turn
the
receiver,
and
all
connected
components,
on
or
off
at
the
same
time.
A\ CAUTION! Do not connect any components that consume more power than the
capacity of the AC outlet. This capacity is indicated below the socket on the
back of the receiver.
IMPORTANT!
Do
not
use
the
AC
outlet
on
the
receiver
fo
connect
the
power
supply
of
the
COMPU
LINK
component.
Otherwise
the
COMPU
LINK
remote
control
system
may
not
work
correctly.
‘AC OUTLET AC OUTLET
SWITCHED SWITCHED
For
continental
Europe
_—_—
For
the
U.K.
For
Australia
For
other
areas
Page 5