168 JVL Industri Elektronik A/S - User Manual - Ethernet for MAC and MIS motors
7.2 Commissioning
Setup poll registers
11. When connected it is possibly to change the polling of registers in the motor by right-
clicking in the default “Mbpoll1” window and selecting “read/write definition”. In the
shown example below is chosen “Address:” 20 (= register 10), and “Quantity:” 6 (=
3 x 32bit registers). This means that register 10, 11 and 12 is polled.
12. By choosing File and New a second poll window is opened where “Address:” 70 and
“Quantity:” 2 is chosen. Meaning that error register 35 is polled. Your screen should
now look something like this:
To Next Page
Loading...