94 JVL Industri Elektronik A/S - User Manual - Ethernet for MAC and MIS motors
4.4 Commissioning
4.4.3 MacTalk Ethernet configuration
The module is by default setup with the following Ethernet configuration:
After adjusting all settings press “Apply and save“
for the settings to take effect and for permanently saving the setup.
Information such as EtherNet/IP firmware version, MAC-address and module status is
displayed in the “Status” -field. Notice that the MAC-address is unique for each module
and can not be changed.
A label at the front plate of the module also indicate the MAC-address.
Basic use of MacTalk is described in the MAC-motor manual (lit. no. LB0047-xxGB)
IfDHCPisenabled,thenmakesureaDHCPserverisavailableonthesamelocalnetwork.
To Next Page
Loading...