7. Install the ceramic plate A into the
dispenser valve. The upper side should be
the side of slot, and it should be covered
with oil(SYN-setral-Al/C 2-FD).
8. Install the ceramic plate B into the
dispenser valve. Both sides should be
covered with oil((SYN-setral-Al/C 2-FD).
9. Install the seal on the dispenser valve
top cover.
10. Assemble dispenser valve top cover and
water distributor together.
11. Put the dispenser valve silicon plate into
the slot of the water distributor.
12. Assemble the ceramic plate C on
dispenser valve silicon plate, the smooth side
should be covered with oil(SYN-setral-Al/C
2-FD).
To Next Page
Loading...
