Work premises
Perform maintenance in clean premises to prevent impurities from
getting into the devices on the machine. Protect the premises
against dust from the environment, for example, if sand and metal
particles get into the oil and other fluid systems of the devices,
severe damage will be caused to the devices.
Make sure that maintenance can be performed without compromis‐
ing occupational safety.
Make sure that the used oils, greases, and fluids are delivered to a
hazardous waste collection point in accordance with the applicable
instructions.
Tilting the cab
For different maintenance procedures it is necessary to tilt the cab
to maintenance position. For correct procedure see:
Operator's
Manual
, Section
6 Inspection and maintenance
, Chapter
6.2 Mainte‐
nance
, Paragraph
Tilting the cab
.
Reporting
Document the maintenance procedures carefully, writing down any
defects detected and repairs made.
If you notice any defects, inform your supervisor or the person
responsible for the maintenance of the machine immediately..The
defects must be repaired before you continue to use the machine.
Store the reports carefully so that they are easily available when
needed.
4 C Preventive maintenance – For the service personnel
TL2 Maintenance Manual
591 003 Default
To Next Page
Loading...
