KaControl for Door Air Curtains
INSTALLATION AND OPERATING INSTRUCTIONS
47
Door air curtains 1.96
14. KaController Parameters
14.1 General
Special user requirements can be enabled and disabled by means of
parameters settings in the KaController.
For example, the minimum and maximum setpoint temperature can
be set using parameters in the KaController.
14.2 Calling up the KaController Parameter Menu
The following steps are needed to set the parameters:
1. Switch off the door air curtain by:
• Pressing the ON/OFF key
or
• Pressing the navigator for a minimum of 5 seconds
or
• Turning the navigator to the left until OFF appears
2. Call up the Parameter menu by pressing the navigator for a
minimum of 10 seconds. The display shows "Para" and then "CODE"
with the value 000 in sequence.
3. Select the password (Code) 11 by turning the navigator and confirm
by pressing the navigator. You are now in the KaController's
Parameter menu,
4. Parameters can now be set using the navigator dial.
Setting parameters:
• Select the parameter by turning navigator
• Call up Edit mode by pressing navigator
• Set the required value by turning navigator
• Save the new value by pressing navigator
There are 3 options for exiting the Parameter menu and calling up the
standard view:
• If no action is carried out using the navigator for longer than 2
minutes
• Hold down navigator for 5 seconds
• Turn navigator and select "ESC" in the display and confirm by
pressing navigator
To Next Page
Loading...
