Kane 458s - Pressure Measurement Good Practice; Large Bore Tubing Issues

24 KANE 458s MANUAL
PRESSURE MEASUREMENT GOOD PRACTICE
WARNING
Before using your analyser to measure an appliance’s gas/air ratio valve,
read the manufacturer’s instructions thoroughly. If in doubt contact the
manufacturer.
After adjusting a gas/air ratio valve you must ensure CO, CO₂ & CO/CO₂
ratio readings are within the manufacturer’s specied limits.
LARGE BORE TUBING ISSUES
If using lager bore tubing when performing pressure tests:
Push orange tube over the rim of the
spigot to ensure a gas tight seal.
This may not produce a gas tight seal.