Kane 905 - Sub Menu - 4. Set Up: CO Alarm and Print

KANE905 Operators Manual Page 26
use to move right to the next.
Move along until all characters spell the
desired name or phone number. If you
need to go back and change a character
use to move left.
Press to return to the SET UP
menu.
CO MENU:
Once an alarm has been exceeded the
display will flash every two minutes
warning the user of an alarm state and
display the gas concentration.
-- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
CO ALARM
1010 ppm
-- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --
A similar display will be shown during a
RECHARGE BATTERY and PUMP OFF
alarms.
Press to return to the SET UP
menu.
CO
ALARM:
Allows an alarm level to be set on for the
CO reading. This is set as a default at
1000ppm.
OFF
0-4000ppm
PRINT:
Allows printer type to be changed.
Note: Wireless passkey is 1111
KMIRP
(default)
KMIRP2
WIRELESS
(if fitted)