9.16 Assist programm: “duration to cut-
off“ (2600)
By pressing foil switch “up“ or “down“
“ call up the assist programm “durat. To
cut-out“ and press foil switch enter
By pressing foil switch “up“ or “down“
select the chosen time until the cut off
point of the suction (between 3 and 20 sec-
onds)
Programm your selected time to cut off
with foil switch enter.
Factory setting: 3 seconds
9.17 Assist programm “memory time“
(2650)
By pressing the foil switch “up“ or
“down“ call up the assist programm
“memory time“ and press foil switch
“enter“ .
By pressing foil switch “up“ or “down“
select the desired memory time. The
memory time can be anything between 0
and 20 seconds. Memory time means, the
time that the ABSORmatic
plus “remem-
bers“ a manually adjusted suction strength
of a connected machine or workbench. If
the machine or workstation gets activated
again within the “memory time“ the
suchtion strength will be as it was just
before cut off. Once the memorised “mem-
ory time“ lapse has elapsed, the absormatic
plus will start again, when activated, with
the suchtion strength that was programmed
in under the assist programm “adjustment“.
With the foil switch “enter“ programm
in “memory time“.
Factory setting: 5 seconds
9.18 Assist programm “software-ver-
sion“ (2700)
By pressing foil switch “up“ or “down“
call up assist programm “software-ver-
sion“.
Once there the display will show software-
version used in this particular
ABSORmatic
for example “SW- Version
2.0“.
9.19 Assistprogramm “time of regular
filter cleansing“ (2750)
By pressing foil switch “up“ or “down“
, call up the assist programm “filter
cleans.time. Then press enter .
By pressing foil switch “up“ or foil
switch “down“ adjust the intervalls of
the regular filter cleansing (adustable
between every 5 and 120 minutes) to the
requirements needed.
Programm the filter cleansing time with the
foil switch “enter“ .
Factory setting: 60 minutes
25
ABSORmatic
®
plus.
To Next Page
Loading...
