Kaypro 10 - RESTORE Procedure

Suppose you are cleaning out your disk box and find an unmarked disk contain-
ing MUFBAR .005. You don't know to which backup it belongs or where its cor-
responding MUFBAR. 001 through ,,004 files are. You may run MUFLOOK and in-
sert this disk. It will notice that there are no MUFBAR.001 ".004 files and it will
begin with MUFBAR.005 and it will show you its header. After it has found a
MUFBAR file, it expects you to supply it with disks in the proper numerical
order. In our example, it would expect MUFBAR.006 next. The program will con-
tinue to ask for MUFBAR.006 until it finds it. You might not have that disk
available, so just exit the program by entering CTRL-C.
4.0 RESTORE
MUFREST is the program used to restore to the hard disk the files created by
MUFBACK .
You may restore only one or a few of a group of files from a particular backup
run, but it is not possible to restore only part of a particular file .
Here is an example. Let's assume your backup consists of several
MUFBAR.nnn files which were created by the specification A:FILE?DAT. You
can, if you wish , restore a single file, such as FILEC. DAT , and leave the others
alone .
To beg i n the restore process:
1. Have
the proper floppy disks available .
2. Know what files each disk contains . The MUFLOOK program may be of
assistance.
3. Put the first diskette in the drive.
WARNING: THE CURRENT DEFAULT DRIVE SHOULD NOT BE THE FLEX-
IBLE DISK DRIVE.
For example, if A: is the hard disk and B: is the flexible
disk, then the CP/M prompt should be A> not B>.
4.
To use the MUFREST utility , type : MUFREST
89