KBL 3500 - Connecting the Sunbed; Connecting the Power Supply

13
Operating Instructions KBL 3500
Connecting the sunbed
Connecting the power supply
The power supply must be connected according to national
standards. This may only be carried out by qualifi ed expert staff.
DANGER
Live components
Danger to life due to electric shock when touching live parts.
Switch off mains voltage.
Protect against re-connection.
•
•
The connection to the 220 V power-supply system has to be protected
by fuses. Their specifi cations can be found under “Technical Data”. A
ground fault circuit interrupter has to be used in any circumstance.
The power supply is connected to X.0. The connection cable has to
conform to the specifi cations mentioned under “Technical Data”.
Feed the power cable through the feedthrough
on the back side of the unit.
Inside the unit, feed the cable through the PG
connection at the electronics carriage.
Connect to X.0.
The sunbed is by default set up to
operate on 3 phases but it can be changed over to 2-phase operation.
1.
2.
3.
Power connectionPower connection