15
Operating Instructions KBL 3500
Start-up
Fix the supplied sign or one with the following wor-
ding to the wall close to the tanning unit:
Warning
UV radiation can cause eye and skin injury. Please
ask the studio staff for further information.
Wear protective goggles.
Certain medications or cosmetics can increase
the sensitivity of the skin to UV radiation.
•
•
•
Determine the presettings for the sunbed in the service menu.
Store the instructions in a place that allows easy access.
Operating modes
The three different operating modes are explained below.
The unit is not operative, i.e. it is connected to the power supply but
it is not used. The tubes and facial tanners are switched off. From the
standby mode, you can change to tanning mode or service mode.
The tubes and facial tanners are switched on and tanning
proceeds. During the tanning mode, the settings for the current
tanning session can be changed via the control panel.
After the tanning session, the fan runs on for 3 minutes to cool down the bed.
In the service mode, the presettings for the tanning mode are
determined and you are prompted for values for the operation
of the unit. The tubes and facial tanners are switched off.
•
•
Standby modeStandby mode
Tanning modeTanning mode
Fan run-onFan run-on
Service modeService mode
To Next Page
Loading...
