Operating Instructions KBL 3500
32
Maintenance intervals
Component/wearing part Cleaning Replacement
Tubes and starters Tubes after approx.
200 operating hours
After 500
operating hours
Lamp of the facial tanner After approx. 200
operating hours
After 500
operating hours
Filter mat, base part Clean after 100 operating hours,
replace when necessary.
Filter mat, upper part Clean after 100 operating hours,
replace when necessary.
Acrylic panes When necessary. After approx. 3000
operating hours
Filter pane of the facial tanners When necessary. After approx. 5000
operating hours
Gas spring of the lifting mechanics — After approx. 3 years
Cleaning and replacing the acrylic panes
The acrylic panes can exhibit small inclusions and reams. Hairline
cracks can also develop during operation. This does not or hardly
affects the tanning properties and does not represent a quality fl aw.
The canopy pane is cleaned when necessary. The cleaning
and care instructions have to be observed. The outer surface
can be cleaned without any preparatory works. In the
following, we describe how to clean the inner surface.
Fold up the canopy of the sunbed.
Undo the 3 screws that fi x the pane to the canopy in the front area. To
undo the screws, a quarter turn to the right will do - they are quick-release
fasteners. The cover with the screws folds down.
1.
2.
Cleaning the
canopy pane
Cleaning the
canopy pane
To Next Page
Loading...
