KBL 3500 - Maintenance and Cleaning; Instructions for Cleaning and Care

31
Operating Instructions KBL 3500
Maintenance and cleaning
Regular maintenance is required for the safe operation of
the sunbeds. Cleaning has to be performed when necessary.
Maintenance and cleaning may only be carried out if the sunbed
is completely disconnected from the power supply.
DANGER
Live parts
Danger to life due to electric shock when touching live parts.
Always switch off the fuses before opening the unit to
ensure that it does not carry any voltage.
Protect the unit against re-connection.
•
•
Instructions for cleaning and care
Before cleaning, take off any rings, bracelets, watches etc. that you
are wearing in order to avoid scratching the surfaces.
It must be avoided at any rate that any cleaning fl uid runs into the
appliance.
To preserve the tanning power we recommend cleaning the tubes and
UV lamps with warm water and a chamois after approx. 200 hours of
operation.
For the acrylic panes use the special cleansing agent and disinfectant
“megaClean” supplied by KBL and dilute it in water at a ratio of 1:13.
To clean the varnished and plastic surfaces, use a damp soapy cloth.
Do not clean the big plastic parts with a dry cloth. This might scratch
the surfaces!
The surfaces and the acrylic panes must not be cleaned with
concentrated disinfectants or solvents or other liquids that
contain alcohol!
•
•
•
•
•
•
•
GeneralGeneral
TubesTubes
Acrylic panesAcrylic panes
Varnished and
plastic parts
Varnished and
plastic parts
Cleansing agentCleansing agent