Operating Instructions KBL 3500
52
Remove the tube covers on the right side and on the left side.
To do so, take hold of the tube cover with both hands close to the edge,
pull straight towards the centre of the sunbed, and take it out in a
downward movement. Make sure that you pull out the lateral parts of the
cover completely without canting them.
Remove the fi rst 4 to 5 tubes by turning each a quarter
forwards or backwards and pulling it out. This should give
you enough room to replace the decorative lighting.
Pinch the coloured jacket of the decorative lighting, loosen the tube by
turning it a quarter, and pull it out.
Replace the starter.
Insert the new tube for the decorative lighting into the jacket and install it.
Installing the tubes: Make sure that the inscriptions on the
tubes are visible, or else there will be no tanning effect.
Assembly is performed in reverse order. The quick-release
fasteners of the pane are screwed down as follows: Bring
the screw slot into a horizontal position with a screwdriver
and press against it until the lock catches.
4.
5.
6.
7.
8.
9.
10.
To Next Page
Loading...
