EasyManua.ls Logo

KEEWAY ATV250 - Page 73

KEEWAY ATV250
97 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
69
T h e r e l a t i o n a l o f m a t t e r s o f t h e b a t t e r y
Proportion
Full accumulation:1.220-1.240.
Term of electrification:<1.220.
Use densimeter to check the battery.
Warning
Disassemble the cathode perior to the anode.
Replace it if the protuberance is cankered by sulfate
Replace it if there is too much deposition at the bottom.
Electrification
Electrification of the proportion of it is less than 1.220, adjust it acconding to the temperature.
Current
Of electrification
Type 7.0AH0.7A
Type 9.0AH0.9A
Time of
Electrification(m)
New:8-12
Old:12-14.
Warning
Open all the caps before electrification
Keep the accumulater for away from fire
Ttub on the electrical switch during electrification
Electrification is forbidden if the temperature of electrolyte is higher than 45
Avoid quick electrification.
Assembly
Assemble anode perior the cathode.
Capability
12V 9.0A.H.
Charger
for suggestion
ManufacturerELAK TypeC1/48
Liquid densimetre
for advise
ManufacturerTHIMSON Type108
NOTE: 1Fill the battery with distilled water up to the limit (using acidity liquid
to fill the old battery is forbidden)
2Make sure the battery full of electrolyte is electrificate under a cool
condition
3Asure that the aeration tube is not jammed or bended the aeration tube must
be expendtie
4If the cycle knockes off for a long time, electrificate it first, then connect the anode
to the body (disassembl the cathode of the battery).

Table of Contents

Related product manuals