Section 2: Using the front-panel interface Model 2651A High Power System SourceMeter® Instrument User's Manual
2-4 2651A-900-01 Rev. A / March 2011
To change a value using the navigation wheel
:
1. Turn the navigation wheel
to go to the character you want to change (the character blinks
when selected).
2. Press the navigation wheel
to edit that character.
3. Turn the navigation wheel
to change the value.
4. Press the navigation wheel to enter the change.
5. Repeat these steps as needed to change the value.
6. Press the ENTER key or the navigation wheel
when finished changing all the characters.
To change a value using the numeric keypad:
NOTE
The numeric entry method may only be used if the numeric keypad is enabled.
1. If the keypad is disabled, press the MENU key, then select DISPLAY > NUMPAD > ENABLE.
2. Use the CURSOR arrow keys to move the cursor to the value that you want to edit.
3. Press any of the desired number keys (0-9, +/-, 0000). The cursor moves to the next value on
the right.
4. Repeat the above steps as required to set the desired values.
5. Press the ENTER key to select the value or press the EXIT (LOCAL) key to cancel the change.
6. (Optional) Press the EXIT (LOCAL) key to return to the main menu.
To Next Page
Loading...
Need help?
General
