To Next Page

To Previous Page

IEEE-488 Reference

3-146

ger Link output line. For all other control source selections, the output trigger pulse is available

at the METER COMPLETE Output connector. The output trigger in these two layers is disabled

when the source bypass is disabled.

The output trigger in the measure layer is always enabled and occurs after the device action.

With ACCeptor selected, the bypass is disabled, This simply means that operation will not pro-

ceed through the speciﬁed layer until the appropriate event occurs.

:ASYNchronous commands

:ILINe <NRf>

:ARM[:SEQuence[1]][:LAYer[1]]:TCONﬁgure:ASYNchronous:ILINe <NRf> Select input trigger line; arm

layer

:ARM[:SEQuence[1]]:LAYer2:TCONﬁgure:ASYNchronous:ILINe <NRf> Select input trigger line; scan

layer

:TRIGger[:SEQuence[1]]:TCONﬁgure:ASYNchronous:ILINe <NRf> Select input trigger line; mea-

sure layer

Parameters <NRf> = 1 Line #1 <NRf> = 4 Line #4

2 Line #2 5 Line #5

3 Line #3 6 Line #6

Query :ILINe? Query programmed input line #

Description These commands are used to select an input line for the asynchronous Trigger Link of the spec-

iﬁed layer. Keep in mind that asynchronous Trigger Link input and output (see :OLINe) cannot

share the same line. If you assign the input to a line that is already being used for the output, an

error occurs and the command is ignored.

:OLINe <NRf>

:ARM[:SEQuence[1]][:LAYer[1]]:TCONﬁgure:ASYNchronous:OLINe <NRf> Select output trigger line;

arm layer

:ARM[:SEQuence[1]]:LAYer2:TCONﬁgure:ASYNchronous:OLINe <NRf> Select output trigger line;

scan layer

:TRIGger[:SEQuence[1]]:TCONﬁgure:ASYNchronous:OLINe <NRf> Select output trigger line;

measure layer

Parameters <NRf> = 1 Line #1 <NRf> = 4 Line #4

2 Line #2 5 Line #5

3 Line #3 6 Line #6

Query :OLINe? Query programmed output line #

Description These commands are used to select an output line for the asynchronous Trigger Link of the spec-

iﬁed layer. Keep in mind that asynchronous Trigger Link input and output cannot share the same

line. If you assign the output to a line that is already being used for the input, an error occurs

and the command is ignored.

Keithley 6517A User Manual

Other manuals for Keithley 6517A