Kemper 330 - Storage; Storage at End of Harvesting Season; Removing Harvesting Unit from Storage

Storage
KM00321,000019E 1912JUN091/1
ZX,688RHU010145 1901NOV971/1
Storage at End of Harvesting Season
•
Store the rotary harvesting unit in a dry place. If
possible, store on level surface.
•
Clean the rotary harvesting unit carefully and check
all the slip clutches. Make any readjustments that
may be necessary. In the Service Section, see Relieve
Pressure on the Main Drive Slip Clutches.
•
Lubricate the rotary harvesting unit or drain oil as
indicated.
•
Check the rotary harvesting unit for damaged or worn
parts and replace them as necessary. For more detailed
checks, see your KEMPER dealer.
•
Touch up the paintwork if required, and clean the decals.
KM1000902 —UN—12JUN09
Removing Harvesting Unit from Storage
If necessary, give the harvesting unit a thorough clean.
Lubricate the harvesting unit. See ”Lubrication and
Maintenance” Section.
Tighten all screws and make sure they are seated firmly.
Check all clutches as shown in ”Service” Section.
Carry out all the operations described under ”Lubrication
and Maintenance”.
Read the Operator’s Manual once again.
CC7616 —UN—21MAR95
551
040810
PN=108