Kemper 330 - Before Start of Season; Daily Maintenance (Or More Often if Necessary)

Lubrication and Maintenance
KM00321,0000295 1924FEB101/1
KM00321,0000296 1924FEB101/1
ZX,688RHU009812 1901NOV971/1
Every 3 Years  Change Coolant of Main Drive Friction Clutch (If
Equipped, Standard on Model 375)
CAUTION: Never attempt to open drain or filler
plug (B) when the friction clutch is hot! Wait until
friction clutch has cooled down. First loosen
plug (B) by one turn to relieve pressure.
The cavity of the friction clutch (A) can be drained and
refilled. This service work requires the friction clutch to
be removed from the machine. Therefore, it is advised
to contact your KEMPER dealer to drain/refill the friction
clutch.
Specification
Main drive friction clutch
cavity—Capacity........................................................ 1.3 L (0.34 US gal.)
ZX1040656 —UN—12APR07ZX024271 —UN—07MAR01
Before Start of Season
Before the rotary harvesting unit is put into service,
perform a general check of the main drive friction clutches.
See Main Drive Friction Clutches (330, 345 and 360) in
Section Service.
Run the machine and check all bearings for overheating
and impermissible play.
Daily Maintenance (Or More Often
if Necessary)
Check all cleaners (blunt or incorrectly positioned cleaner
will cause plugging and expose drive system and friction
clutches to unnecessary load).
After operating for a few hours check that all bolts are
firmly seated; this also applies after changing blades or
cleaners.
Clear the area around the gathering drums, rotating
blades and scrapers of husks and bits of stalk.
Check all transmissions for signs of oil leaks.
Check cutting blades and replace them if worn (dull
blades will cause extremely long stubble and expose drive
system and friction clutches to unnecessary load).
459
040810
PN=94