Kemper 330 - General View of Drives and Oil Levels in the Rotary Harvesting Unit (Part 1)

Lubrication and Maintenance
KM00321,000028B 1924FEB101/1
General View of Drives and Oil Levels in the Rotary Harvesting Unit (Part 1)
KM1001132 —UN—24FEB10
360 Rotary Harvesting Unit Shown
A—Oil drain plug
B—Oil filler screw
C—Breather
D—Oil level screw
1— Spurgear transmission of
feed drum (permanently
lubricated)
2— Spur gear angle drive  1.0 L
(0.26 US. gal)
3— Spur gear angle drive of cross
feed drum  0.85 L (0.22 US.
gal)
Rotary harvesting unit transmission
NOTE: Six spur gear angle drives (3) for cross feed
drums are used on 375, four on 360 and two
on 345 rotary harvesting unit.
NOTE: 330 rotary harvesting unit is not equipped with
spur gear angle drives (3) for cross feed drums.
452
040810
PN=87