Kemper 330 - Channel Width Adjustment; Improved Channel Width Adjustment

Attaching to a CLAAS Forage Harvester
KM00321,000025E 1929JAN101/2
KM00321,000025E 1929JAN102/2
KM00321,0000265 1929JAN101/1
Channel Width Adjustment
The channel width of forage harvester and rotary
harvesting unit must be the same.
Preset channel width
Preset channel width (X) for narrow intake (forage
harvester types 685  695) is 570 mm (1 ft. 10.44 in.) and
for wide intake (forage harvester types 820  980) 660
mm (2 ft. 1.98 in.).
X—Preset channel width
KM1001085 —UN—29JAN10
Adjust channel width
The channel width of the rotary harvesting unit can be
adjusted, if required.
Procedure:
Loosen attaching screws (A).
Cover, feed plate and scraper assembly (B) can be turned
round the feed drum (C) to modify channel width.
IMPORTANT: After adjustment, make sure that
clearance between scraper and wall of feed
drum does not exceed 5 mm (0.2 in.). See
Scrapers on Feed Drums in Section Service.
Tighten attaching screws (A).
A—Attaching screws
B—Scraper assembly
C—Feed drum
ZX1040566 —UN—13APR07ZX1040567 —UN—12APR07
Improved Channel Width Adjustment
If the section between the housing and the feed plates
is regularly blocked, adjust the channel width in such a
way that the feed plates cover the outer edge of the front
feed rolls.
ZX1041090 —UN—19SEP07
252
040810
PN=27