Kemper 330 - Install Mounting Rail

Attaching to NEW HOLLAND and CASE Forage Harvesters
KM00321,000025B 1911FEB101/1
KM00321,0000276 1918FEB101/1
Install Mounting Rail
IMPORTANT: Mounting rail (A) is supplied separately
with the rotary harvesting unit and must be
installed on the forage harvester first.
Secure mounting rail (A) in middle holes (2, 3 and 4) of
the pattern on the feed roll housing.
A—Mounting rail
KM1000877 —UN—27MAY09
Install Front Jackstand
When attaching or detaching, the rotary harvesting unit
stands on three jackstands. Two jackstands (A) are
located at the bottom of the attaching frame. When the
implement is delivered, front jackstand (B) is mounted to
the upper crossmember of the attaching frame.
Before attaching the rotary harvesting unit for the first
time, the front jackstand must be installed:
•
Set the rotary harvesting unit down on a flat level paved
surface.
•
Raise the rotary harvesting unit with a crane or a forklift.
CAUTION: When working underneath the rotary
harvesting unit, it must be supported securely.
CAUTION: Make sure that the crane or forklift
meets the weight requirements of the rotary
harvesting unit (see Section Specifications).
•
Remove dummy plug and install front jackstand (B).
A—Rear jackstand B—Front jackstand
KM1001109 —UN—18FEB10KM1001108 —UN—18FEB10
302
040810
PN=40