Kemper 330 - Install U.J. Shaft Shields on Forage Harvester

Attaching to NEW HOLLAND and CASE Forage Harvesters
KM00321,0000270 1911FEB101/1
Install U.J. Shaft Shields on Forage Harvester
On forage harvesters with infinitely variable
lengthofcut adjustment "HydroLoc" only
Cover both splined shafts (A) and (B) with protection
device (D).
Depending on which splined shaft is used (A or B), cover
plate (1) must be installed at the top or at the bottom of
strap (2).
Depending on which splined shaft is used (A or B), shaft
shield (3) must be installed at the top or at the bottom.
Cover hydraulic motor (C) with protective cover (4).
Remove the equipped strap.
A—Splined shaft
B—Splined shaft
C—Hydraulic motor
D—Protection device
1— Cover plate
2— Strap
3— Shaft shield
4— Protective cover
KM1000882 —UN—27MAY09
307
040810
PN=45