Attaching to NEW HOLLAND and CASE Forage Harvesters
KM00321,0000271 1918FEB101/1
KM00321,000026F 1918FEB101/1
Lock Jackstands
Lock rear jackstands (A) in their highest position.
Remove front jackstand (B) and replace it with the dummy
plug provided.
NOTE: When the rotary harvesting unit is attached to
the forage harvester, slide front jackstand (B) into
the bracket provided on the attaching frame.
A—Rear jackstand B—Front jackstand
KM1001109 —UN—18FEB10KM1001108 —UN—18FEB10
Connect Drive Shaft
Connect drive shaft (A) to feed roll housing and to drive
case of rotary harvesting unit.
CAUTION: To avoid serious injury, make sure that
locking pins of drive shaft are engaged properly
in the provided grooves on the splined shafts.
A—Drive shaft
KM1000881 —UN—27MAY09
306
040810
PN=44
To Next Page
Loading...
