Kemper 330 - Transport with Rotary Harvesting Unit Installed; Ballasting for Safe Ground Contact

Safety
KM00321,000024F 1912JAN101/1
KM00321,0000250 1912JAN101/1
DX,PAINT 1924JUL021/1
Transport with Rotary Harvesting
Unit Installed
Before driving the forage harvester on public roads, the
rotary harvesting unit must be raised and secured in
the raised position. It must not, however, obstruct the
operator’s view of the road.
KM1001078 —UN—12JAN10
Ballasting for Safe Ground Contact
Operating, steering and braking performance of forage
harvester can be considerably affected by attachments
which alter the center of gravity of the machine. To
maintain safe ground contact, ballast the forage harvester
at the rear end as necessary. Observe the maximum
permissible axle loads and total weights.
KM1001079 —UN—12JAN10
Remove Paint Before Welding or Heating
Avoid potentially toxic fumes and dust.
Hazardous fumes can be generated when paint is heated
by welding, soldering, or using a torch.
Remove paint before heating:
•
Remove paint a minimum of 100 mm (4 in.) from area
to be affected by heating. If paint cannot be removed,
wear an approved respirator before heating or welding.
•
If you sand or grind paint, avoid breathing the dust.
Wear an approved respirator.
•
If you use solvent or paint stripper, remove stripper with
soap and water before welding. Remove solvent or
paint stripper containers and other flammable material
from area. Allow fumes to disperse at least 15 minutes
before welding or heating.
Do not use a chlorinated solvent in areas where welding
will take place.
TS220 —UN—23AUG88
Do all work in an area that is well ventilated to carry toxic
fumes and dust away.
Dispose of paint and solvent properly.
057
040810
PN=17