Kemper 330 - Rotary harvesting unit with rigid frame

Attaching to a CLAAS Forage Harvester
KM00321,0000259 1910FEB102/2
Rotary harvesting unit with rigid frame
1. Unlock lever (A).
2. Drive the forage harvester close to the rotary
harvesting unit’s frame until attaching straps (B)
protrude into mounting brackets (D) of the attaching
frame.
3. Raise front shield (C).
4. Lock rotary harvesting unit by engaging lever (A).
5. Lock jackstands (F) in their highest position.
Adjust lever (A) (only for initial use):
•
Loosen screws (E).
•
Adjust lever (A) so that it can be secured.
•
Tighten screws (E).
IMPORTANT: Secure lever (A) with spring pin.
A—Lever
B—Attaching straps
C—Front shield
D—Mounting bracket
E—Screws
F— Jackstands
KM1001092 —UN—04FEB10KM1001090 —UN—04FEB10KM1001093 —UN—04FEB10KM1001094 —UN—05FEB10
256
040810
PN=31