Kemper 330 - Page 33

Attaching to a CLAAS Forage Harvester
KM00321,0000268 1909FEB102/2
360 and 375 rotary harvesting units
1. Install spacer bushings (A).
2. Extend the equipped shield by attaching sheet (B).
3. Install protective cover (C).
4. Connect u.j. shaft (D).
IMPORTANT: Secure the u.j. shaft (D) with locking
screws on both sides.
Make sure that u.j. shaft can no longer move.
A—Spacer bushings
B—Sheet
C—Protective cover
D—U.j. shaft
KM1001098 —UN—09FEB10KM1001099 —UN—09FEB10
258
040810
PN=33