Operation of the Rotary Harvesting Unit
KM00321,000027F 1919FEB102/2
Instructions to prepare the rotary harvesting unit
If the crop is lying down, install stalk lifters (B) on each
small divider (A).
Check main drive slip and friction clutches before the
beginning of the season. See Main Drive Slip Clutches
WaterCooled (Optional on 345 and 360, Standard on
375), or Main Drive Friction Clutches (330, 345 and 360)
in Section Service.
Sharp blades and undamaged cleaners are essential.
Install whole crop silage kit. This will significantly improve
crop feeding (see Retrofit for Whole Crop Silage in this
Section).
Adjust the scrapers as close as possible to the gathering
and feed drums.
Install the inner large dividers as high as possible, see
Adjusting the Large Dividers in this Section.
ZX1040575 —UN—12APR07
A—Small divider B—Stalk lifter
305
040810
PN=57
To Next Page
Loading...
