Kemppi Kempact Pulse 3000 Operating Manual

EN
Filling the reservoir:
Fill the reservoir with a 20 – 40 % mixture of etanol and water, or with any other suitable
antifreeze. The capacity of the reservoir is 3 litres.
3. OPERATION
3.1 Main switch and signal lights
With the switch in the ‘I’ position, the primary and control circuits of the machine become
live and the ‘ON’ signal light on the panel lights up. The welding circuit receives voltage when
the gun switch is operated or when the wire feed test switch is pressed. Always use the main
switch to turn the machine on and o with the main switch; do not use the power plug for this
purpose.
3.2 To select polarity for welding
Solid wire is usually welded in the +pole and gasfree ller wires in the - pole gun. When
welding with other ller wires, check for the recommended polarity on the package or consult
the supplier of the product. The welding of very thin steelplates (0.5 to 0.7 mm) a - polarity
might also work best for solid wire.
3.2.1 Changing the polarity
- pole
+ pole
NOTE! Only a service shop authorised by Kemppi may change the polarity.
Kempact Pulse 3000, KempactCool 10
10

Kemppi Kempact Pulse 3000 Specifications

General

Brand	Kemppi
Model	Kempact Pulse 3000
Category	Welding System
Language	English