EasyManuals Logo

Kemppi Promig 530 User Manual

Kemppi Promig 530
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #27 background imageLoading...
Page #27 background image
Promig 530 / 0612 – 27© kemPPi oy
R61
R63
R20
R10, RMT10
R61
R63 R61
MIG
Setting for wire feed:
I 1…18 m/min
II 1…25 m/min
Setting for voltage:
10 V...max. voltage of power
source (35...46 V)
SELECTO Channel selection: 1...5 corresponding
to settings 1, 4, 6, 8, 10 of knob
Fine adjustment for arc length:
1...10
SYNERGIC MIG
Setting for power (wire feed speed):
according to wire min. ... max.
Fine adjustment for arc length:
1...10
SYNERGIC
PULSED MIG
Setting for power (wire feed speed):
according to wire min. ... max.
Fine adjustment for arc length:
1...10
MMA
Setting for power:
10 A...max. power of power source
NO OPERATION
R61
MIG
Setting for wire feed:
I 1…18 m/min
II 1…25 m/min
SELECTO Channel selection: 1...5 corresponds in
the R10 settings 1, 4, 6, 8, 10 of knob
SYNERGIC MIG
Setting for power (wire feed speed):
according to wire min. ... max.
SYNERGIC
PULSED MIG
Setting for power (wire feed speed):
according to wire min. ... max.
MMA
Setting for power:
10 A...max.power of power source
NOTE ! RMT10
NO OPERATION
4. OPERATIONS OF REMOTE CONTROL UNITS IN
PROMIG 530 WIRE FEED UNIT

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kemppi Promig 530 and is the answer not in the manual?

Kemppi Promig 530 Specifications

General IconGeneral
BrandKemppi
ModelPromig 530
CategoryWelding System
LanguageEnglish

Related product manuals