• Inserting the bobbin
End of thread
Notch
Notch
Threading diagram
Place a bobbin in the bobbin holder with the thread
running off counterclockwise.
Guide the thread into the notch _ on the front side of
the bobbin holder.
Draw the thread to the left, sliding it between the tension
spring blades.
Continue to draw the thread lightly until the thread slips
into notch _. Pull out about 6" (15.0 cm) of thread.
Attach the hook cover plate. Check the threading by
referring to the diagram _ shown on the hook cover plate.
S
%
%
\
J
15
To Next Page
Loading...
