Prepare Your Top Thread
Check Your Presser Foot
Your presser foot is held in place by a Foot Holder. Each presser foot merely
snaps on the foot hofder, which is seldom removed.
}f you need to remove or attach the foot holder, here is what you do:
To Remove:
Foot _
holder _
screw
To Remove:
Turn the screw toward the back of the
machine, Use the large screw driver.
To Attach:
Presser bar
To Attach:
1. Match the hole in the foot holder
with the threaded hole _n the
presser bar.
2. Fit the foot holder screw into the
hole.
3, Tighten the screw by turning it
toward you.
22
To Next Page
Loading...
