Prepare Your Top Thread {Continued)
• Thread Your Needle
NOTE: The numbered steps below follow the numbers on the iHustrat=ons,
NOTE: Dotted tines show places where the thread loops and then is pulled tight. Each place has a spring.
®
1. Hotd the thread, as shown. Press the thread 5.
down until _t clicks and comes down under the
hook Jn the top cover thread guide.
2. Draw the thread around the thread guide and 6.
down into the tension area,
3_ Putt the thread up from left to right around the 7.
check spr_ng wire.
4, Draw the thread straight up and from left to 8.
r=ght through the slot and _nto the eye of the
take-up lever.
Draw the thread down and slip it through the
right side of the right-hand thread guide, as
shown,
Pull the thread to the left and slip it through
the left thread guide.
Slide the thread through the needle bar guide
on the left.
Thread the needle from front to back,
NOTE: You may want to cut the end of the
thread w}th sharp scissors for easier
needle threading.
24
To Next Page
Loading...
