Connection/Installation
97English
● Except Indonesia models / DDX9020DABS / DMX8520DABS / DDX8020S / DMX8020S
P. CONT
CAM+
CAM–
PRK SW
REVERSE
S SENS
Accessory 1
When using the optional power amplifier, connect to
its power control terminal. (Max. 200mA, 12V)
Connect to vehicle's harness.
Blue/White
(Power control wire)
If no connections are made, do not let
the cable come out from the tab.
Pin Color and function
A1 Orange/White Dimmer
A2 Yellow Battery
A4 Red Ignition (ACC)
A5 Blue
[1]
Antenna control
A6 Black Earth (Ground) Connection
A8/A7 White (+) / White/Black (–) Front Left
A10/A9 Gray (+) / Gray/Black (–) Front Right
B2/B1 Green (+) / Green/Black (–) Rear Left
B6/B5 Purple (+) / Purple/Black (–) Rear Right
* Speaker Impedance: 4-8 Ω
[1]
Max. 300mA, 12V
Green/White
Green/Red
To CMOS-3xx series (optional accessory) camera control
terminal
Fuse (15A)
Purple/White
(Reverse sensor wire) (2 m)
Pink (Speed Pulse Input) (2 m)
(DDX920WDABS only)
Connect to the vehicle’s speed pulse harness.
Do not cut the "S SENS" tag or failure may result.
Connect to vehicle’s reverse lamp harness when
using the optional rear view camera.
Connect to the vehicle’s
parking brake detection switch
harness.
Light Green
(Parking sensor wire)
(2 m)
For best safety, be sure to
connect the parking sensor.
To Next Page
Loading...
