Kett FD-660 - Control Panel Functions

11
4-4 Control Panel Functions
Item No. Name Description
1
Tare/Reset key
Used to perform zero adjustment (blinks during taring).
Also used to perform a reset after an error has occurred.
Also used to return to display of weight after completion of measurement.
2
Pre Heat key
Used to warm up the whole system before measuring a sample. Also
used to warm up the measuring instrument when it is cooled because of
a long measuring interval (see page 18 for further information).
[Temperature: 130ºC, time: 5 minutes] xed
Replace the sample dish after preheating.
3
Menu key
Used at the start and end of specifying a measuring mode, a drying
temperature, a measurement standard, measurement data output
format, or an offset value.
4
Select key Used to select different settings or setting values.
5
▲ (Up) key Used to raise the setting value.
6
▼ (Down) key Used to lower the setting value.
7
Enter key Used to conrm currently selected settings.
8
Start/Stop key
Used to start measuring or to abort a measuring operation.
Used to forcibly terminate the measurement.
Also used to turn off the alarm which sounds to indicate that a
measuring operation has been completed.
1 2 4
6
3
5
8
7