User Manual
SUPM1
page 81 of 94© KEYMILE December 2015 EN/LZTBU 372 129/1 RC
94
User Interface Reference
Unlock All Ports
b
Unlock all enabled user ports. Ports that have
been blocked previously are unblocked
(unlocked state) with this command.
Unit Line Test Sta-
tus
State
c
Line Test Idle
No line-test is active.
Line Test Running
A line-test is active
Start Line Test
Start a manual line-test on all enabled user
ports.
Stop Line Test
Stop any ongoing cyclic or manual line-tests.
Reset Line Test
Defects
Reset the line-test defects and alarms of all
cyclic or manual line-tests.
a. The unit admin status displays the combined X.731 administrative state of all user ports. Note: This property is only
available for the V5CAS mode of operation.
b. This command is only available for the V5CAS mode of operation.
c. The unit line-test state displays the combined test state of all user ports.
Table 45: AP: / unit-x, Status - Maintenance (continued)
Operation Name Parameter Name Range Description / Details
To Next Page
Loading...