Remote Interface Reference 3
E364xA User’s and Service Guide 145
*SRE <enable value>
This command enables bits in the Status Byte enable register.
*SRE?
Query the Status Byte Enable register. The power supply returns a decimal
value which corresponds to the binary-weighted sum of all bits set in the
enable register.
*STB?
Query the Status Byte summary register. The *STB? command is similar to a
serial poll but it is processed like any other instrument commands.
The *STB? command returns the same result as a serial poll but the “Request
Service” bit (bit 6) is not cleared if a serial poll has occurred.
*WAI
Instruct the power supply to wait for all pending operations to complete before
executing any additional commands over the interface. Used only in the
triggered mode.
To Next Page
Loading...
Need help?
General
